ULTRA-X22XP

Specifications

Operating Frequency Range: 60 Hz – 18 kHz
Frequency Response: 65 Hz – 17.5 kHz ± 4 dB
Phase Response: 95 Hz – 18 kHz ±45°
Linear Peak SPL: 128.5 dB with 20 dB crest factor (M-noise), 123.5 dB (Pink Noise), 125 dB (B-noise)

Low Frequency: Two 5-inch cone drivers; 6 Ω nominal impedance
High Frequency: One 2-inch diaphragm compression driver connected to a rotatable horn; 8 Ω nominal impedance

Type: Differential, electronically balanced
Maximum Common Mode Range: ±15 V DC, clamped to earth for voltage transient protection
Connector: Phoenix 5-pin male
Input Impedance: 10 kΩ differential between Audio (+) and Audio (–)
Wiring: Pin 1: DC Power (–) Pin 2: DC Power (+) Pin 3: Audio Shield, Chassis/earth Pin 4: Audio (–) Pin 5: Audio (+)
Nominal Input Sensitivity: 0 dBV (1.0 V rms) continuous is typically the onset of limiting for noise and music
Input Level: Audio source must be capable of producing of +20 dBV (10 V rms) into 600 Ω to produce the maximum peak SPL over the operating bandwidth of the loudspeaker.

Connector: Phoenix 5-pin male provides power and audio connection (see Wiring above)
Safety Rated Voltage Range: 48 V DC—Meyer Sound MPS-482HP or MPS-488HP Power Supply required (NEC ANSI/NFPA 70 Class 2 Wiring Approved)

Dimensions: W: 7.44 in (189 mm) x H: 19.04 in (484 mm) x D: 8.66 in (220 mm)
Weight: 27 lb (12.3 kg)
Enclosure: Aluminum with slightly textured black finish
IP Rating: Weather-protected version rated IP54 with properly installed rain hood. See the ULTRA-X20XP Operating Instructions for details.
Protective Grille: Powder-coated, round-perforated steel
Rigging: Two integrated M8 threaded points on each end; optional accessories for various rigging options (see accessories section); four M6 threaded holes with 5-inch by 2.75-inch (127 mm by 70 mm) hole pattern on the rear for use with third-party wall mounts.