Meyer Sound

Meyer Sound

MJF-208

Product code
MJF-208
Category
Audio
Family
mjf-208
Weight
21.3 kg

Specifications

ACOUSTICAL

Operating Frequency Range
55 Hz – 18 kHz
Frequency Response
60 Hz – 18 kHz ±4 dB
Phase Response
230 Hz – 16 kHz ±45°
Linear Peak SPL
129 dB with crest factor >16 dB (M-noise)7 128 dB (Pink noise), 129 dB (B-noise)

COVERAGE

Horizontal Coverage
70°
Vertical Coverage
50°

TRANSDUCERS

Low Frequency
Two 8-inch high-power cone drivers; 4 Ω nominal impedance
High Frequency
One 3-inch diaphragm compression driver; 16 Ω nominal impedance

AUDIO INPUT

Type
Differential, electronically balanced
Maximum Common Mode Range
±5 V DC, clamped to earth for voltage transient protection
Connectors
XLR 3-pin female input with male loop output; optional XLR 5-pin connector to accommodate both balanced audio and RMS signals.
Input Impedance
10 kΩ differential between pins 2 and 3
Wiring
Pin 1: Chassis/earth through 1 kΩ, 1000 pF, 15 V clamp network to provide virtual ground lift at audio frequencies Pin 2: Signal + Pin 3: Signal – Pin 4: RMS (polarity insensitive) Pin 5: RMS (polarity insensitive) Case: Earth ground and chassis
Nominal Input Sensitivity
0 dBV (1.0 V rms) continuous is typically the onset of limiting for noise and music
Input Level
Audio source must be capable of producing of +20 dBV (10 V rms) into 600 Ω to produce the maximum peak SPL over the operating bandwidth of the loudspeaker.

AMPLIFIER

Type
Three-channel, Class-D
Total Output Power
1770 W peak
THD, IM, TIM
< 0.02%
Cooling
Convection

AC POWER

Connector
PowerCON 20 input with loop output
Automatic Voltage Selection
90–265 V AC
Safety Agency Rated Voltage Range
100–240 V AC, 50–60 Hz
Turn-on and Turn-off Points
90 V AC turn-on, no turn-off; internal fuse protection above 265 V AC

CURRENT DRAW

Idle Current
0.26 A rms (115 V AC); 0.25 A rms (230 V AC); 0.28 A rms (100 V AC)
Maximum Long-Term Continuous Current (>10 sec)
1.4 A rms (115 V AC); 0.8 A rms (230 V AC); 1.7 A rms (100 V AC)
Burst Current (<1 sec)
2.2 A rms (115 V AC), 1.1 A rms (230 V AC), 2.6 A rms (100 V AC)
Maximum Instantaneous Peak Current
6.0 A peak (115 V AC), 2.9 A peak (230 V AC), 6.9 A peak (100 V AC)
Inrush Current
< 20 A peak

PHYSICAL

Dimensions
W: 18.68 in (474 mm) x H: 12.68 in (322 mm) x D: 18.60 in (472 mm)
Weight
47 lb (21.3 kg)
Enclosure
Premium multi-ply birch with slightly textured black finish; 35° front angle
Protective Grille
Powder-coated, hex-stamped steel with black mesh

Specification from Meyer Sound