LEOPARD

Specifications

Operating Frequency Range: 55 Hz – 18 kHz
Phase Response: 92 Hz – 18 kHz ±30 degrees
Maximum SPL: 142 dB
Linear Peak SPL: 133.5 dB with 18 dB crest factor (M-noise), 130 dB (Pink noise), 134.5 dB (B-noise)
COVERAGE: LEOPARD
Horizontal Coverage: 110°
Vertical Coverage: Varies, depending on array length and configuration

Low Frequency: Two 9-inch long-excursion cone drivers; 2 Ω nominal impedance
High Frequency: One 3-inch diaphragm compression driver coupled to a constant-directivity horn through a patented REM® manifold; 4 Ω nominal impedance

Type: Differential, electronically balanced
Maximum Common Mode Range: ±15 V DC, clamped to earth for voltage transient protection
Connectors: XLR 5-pin female input with male loop output; XLR 3-pin female connectors available to accommodate only balanced audio (no RMS signals)
Input Impedance: 10 kΩ differential between pins 2 and 3
Wiring: Pin 1: Chassis/earth through 1 kΩ, 1000 pF, 15 V clamped network to provide virtual ground lift at audio frequencies Pin 2: Signal + Pin 3: Signal - Pin 4: RMS (polarity insensitive) Pin 5: RMS (polarity insensitive) Case: Earth ground and chassis
Nominal Input Sensitivity: 6.0 dBV (2.0 V rms) continuous is typically the onset of limiting for noise and music
Input Levels: Audio source must be capable of producing +20 dBV (10 V rms) into 600 Ω to produce the maximum peak SPL over the operating bandwidth of the loudspeaker

Connector: powerCON 20 input with loop output
Automatic Voltage Selection: 90–265 V AC
Safety Rated Voltage Range: 100–240 V AC, 50–60 Hz
Turn-on and Turn-off Points: 90 V AC turn-on, no turn-off; internal fuse-protection above 265 V AC

Idle Current: 0.46 A rms (115 V AC); 0.35 A rms (230 V AC); 0.49 A rms (100 V AC)
Max Long-Term Continuous Current (>10 sec): 3.0 A rms (115 V AC); 1.5 A rms (230 V AC); 3.4 A rms (100 V AC)
Burst Current (<1 sec): 4.4 A rms (115 V AC); 2.3 A rms (230 V AC) 5.5 A rms (100 V AC)
Maximum Instantaneous Peak Current: 12.6 A peak (115 V AC); 6.3 A peak (230 V AC); 14.5 A peak (100 V AC)
Inrush Current: < 20 A peak

Dimensions: W: 26.93 in (684 mm) x H: 11.11 in (282 mm) x D: 21.66 in (550 mm)
Weight: 75 lb (34.0 kg)
Enclosure: Premium multi-ply birch, slightly textured black finish
Protective Grille: Powder-coated, hex-stamped steel with acoustical black mesh
Rigging: End frames with captive GuideALinks secured with 0.3125 in x 0.63 in quick-release pins that allow 0.5° to 15° splay angles; detachable side and rear handles