Meyer Sound
Meyer Sound
HMS-10
- Product code
- HMS-10
- Category
- Audio
- Family
- hms
- Weight
- 11.9 kg
Specifications
ACOUSTICAL
- Operating Frequency Range
- 55 Hz – 18 kHz
- Frequency Response
- 57 Hz – 17 kHz ± 4 dB
- Phase Response
- 290 Hz – 18 kHz ±45°
- Linear Peak SPL
- 125.5 dB with 19.5 dB crest factor (M-noise) , 122 dB (Pink noise), 123.5 dB (B-noise)
COVERAGE
- Horizontal Coverage
- 80°
- Vertical Coverage
- 80°
TRANSDUCERS
- Low Frequency
- One 10-inch long- excursion cone driver; 4 Ω nominal impedance
- High Frequency
- One 2-inch diaphragm compression driver; 12 Ω nominal impedance
AUDIO INPUT
- Type
- Differential, electronically balanced
- Maximum Common Mode Range
- ±15 V DC, clamped to earth for voltage transient protection
- Connectors
- XLR 3-pin female input with male loop output
- Input Impedance
- 10 kΩ differential between Audio (+) and Audio (–)
- Wiring
- Pin 1: Chassis/earth through 220 kΩ, 1000 pF, 15 V clamp network to provide virtual ground lift at audio frequencies Pin 2: Audio (+) Pin 3: Audio (–) Case: Earth ground and chassis
- Nominal Input Sensitivity
- 2.0 dBV (1.3 V rms) continuous is typically the onset of limiting for noise and music. Note: with the Pad switch enabled, the input sensitivity is 9.5 dBV (3.0 V rms)
- Input Level
- Audio source must be capable of producing of +20 dBV (10 V rms) into 600 Ω to produce the maximum peak SPL over the operating bandwidth of the loudspeaker.
AMPLIFIER
- Type
- 2-channel with active crossover
- Total Output Power
- 600 W peak
- THD, IM, TIM
- < 0.02%
- Cooling
- Convection
- Connector
- Two Phoenix 5-pin male
- Voltage Requirements
- N/A
- Automatic Voltage Selection
- 90–265 V AC
- Safety Agency Rated Voltage Range
- 100–240 V AC, 50–60 Hz
- Turn-on and Turn-off Points
- 90 V AC turn-on, no turn-off; internal fuse- protection above
CURRENT DRAW
- Idle Current
- 0.23 A rms at 115 V AC 0.22 A rms at 230 V AC 0.25 A rms at 100 V AC
- Maximum Long-Term Continuous Current (>10 sec)
- 1.3 A rms at 115 V AC 0.7 A rms at 230 V AC 1.5 A rms at 100 V AC
- Burst Current (<1 sec)7
- 2.9 A rms at 115 V AC 1.5 A rms at 230 V AC 3.1 A rms at 100 V AC
- Maximum Instantaneous Peak Current
- 7.0 A peak at 115 V AC 3.8 A peak at 230 V AC 7.7 A peak at 100 V AC
- Inrush Current
- <20.0 A peak
PHYSICAL
- Dimensions
- W: 15.50 in (394 mm) x H: 19.50 in (495 mm) x D: 12.48 in (317 mm)
- Weight
- 26.2 lb (11.9 kg)
- Enclosure
- Premium multi-ply birch with slightly textured black finish
- Grille Frame
- Acoustically transparent, detachable, black cloth-covered frame
- Rigging
- Rear attachment points 3.94 in x 3.94 in (100 mm x 100 mm)
ACCESSORY APPLICABILITY
- FMB-HMS Fixed Bracket
- √
- AMB-HMS Adjustable Bracket
- √
- HY-HMS Half Yoke
- √
- MUB-HMS U-Bracket
- √
- WH-HMS Wall Hinge Bracket
- √