Meyer Sound

Meyer Sound

Acheron 100

Product code
ACHERON 100
Category
Audio
Family
acheron-80---acheron-100---acheron-lf
Weight
83.91 kg

Specifications

ACOUSTICAL

Operating Frequency Range
37 Hz – 18 kHz
Frequency Response
38 Hz – 17 kHz ±4 dB
Phase Response
700 Hz – 17 kHz ±30°
Linear Peak SPL
134 dB with crest factor of 18 dB (M-noise), 133.5 dB (Pink noise), 135 dB (B-noise)

COVERAGE

Horizontal Coverage
100°
Vertical Coverage
N/A

TRANSDUCERS

Low Frequency
Two high-power 15-inch cone drivers with neodymium magnets; 4 Ω nominal impedance

AUDIO INPUT

Type
Differential, electronically balanced
Maximum Common Mode Range
±15 V DC, clamped to earth for voltage transient protection
Connectors
XLR 3-pin female input with male loop output; optional XLR 5-pin connector to accommodate both balanced audio and RMS signals.
Input Impedance
10 kΩ differential between pins 2 and 3
Wiring
Pin 1: Chassis/earth through 220 kΩ, 1000 pF, 15 V clamp network to provide virtual ground lift at audio frequencies Pin 2: Signal + Pin 3: Signal – Case: Earth ground and chassis
Nominal Input Sensitivity
10 dBV (3.2 V rms) continuous is typically the onset of limiting for noise and music
Input Level
Audio source must be capable of producing of +20 dBV (10 V rms) into 600 Ω to produce the maximum peak SPL over the operating bandwidth of the loudspeaker.

AMPLIFIER

Type
Two-channel with complementary MOSFET output stages (class AB/H)
Total Output Power
4500 W peak
THD, IM, TIM
< 0.02%
Cooling
Forced air cooling, two internal fans (one ultra low-speed fan, one reserve fan)

AC POWER

Connector
250 V NEMA L6-20 (twistlock) inlet or IEC 309 male inlet
Automatic Voltage Selection
Automatic, two ranges, each with high-low voltage tap (uninterrupted)
Safety Rated Voltage Range
95–125 V AC; 208–235 V AC, 50/60 Hz
Turn-on and Turn-off Points
85–134 V AC; 165–264 V AC

CURRENT DRAW

Idle Current
0.64 A rms (115 V AC); 0.32 A rms (230 V AC); 0.85 A rms (100 V AC)
Maximum Long-Term Continuous Current (>10 sec)
8.8 A rms (115 V AC); 4.4 A rms (230 V AC); 10.0 A rms (100 V AC)
Burst Current (<1 sec)
19.0 A rms (115 V AC), 9.5 A rms (230 V AC), 22.0 A rms (100 V AC)
Maximum Instantaneous Peak Current
39 A peak (115 V AC), 20 A peak (230 V AC), 45 A peak (100 V AC)
Inrush Current
7 A peak (115 V AC), 7 A peak (230 V AC), 10 A peak (100 V AC)

PHYSICAL

Dimensions
W: 31 in (787 mm) x H: 36.18 in (919 mm) x D: 20.5 in (521 mm)
Weight
185 lb (83.91 kg)
Enclosure
Premium multi-ply birch with slightly textured black finish
Protective Grille
Powder-coated, hex-stamped steel with black mesh
Rigging
3/8-inch threaded points on side corners for optional bracket adapters that allow the Acheron to be mounted to floors with uptilt or downtilt, as well as on top of the Acheron LF (also with uptilt or downtilt)

Specification from Meyer Sound